Salt spray test machine failure? This article will take effect

Salt spray test machine failure? This article will take effect
When the user operates, it may cause various failures due to improper operation or the device itself. Do not worry! This article specifically for everyone summed up the salt spray test machine failure to remove the various methods, easy to see through the list, the disease to the hands of natural addition! The salt spray tester is used for moist heat, salt spray, and mildew, and is known as the "three defenses" for artificial climate. It is widely used in salt spray corrosion tests on plating, coating, etc. of electronic, electric and automobile, motorcycle, hardware tools and other products, components, and metal materials and products.

Fault one: After turning on the power supply, it will not work properly. Troubleshooting: Check whether the water level in the heating tank is too low. When the water level is too low, the equipment will cut off the power supply to ensure the safety of the equipment; therefore, when such failure occurs When checking the water level in the warming water tank, if it still cannot work normally after discharging such malfunctions, it must be a functional malfunction of the salt spray tester equipment. You can contact Dongguan Kewen after-sales department for debugging and repair.

Fault 2: Salt spray test Temperature inside the chassis can not rise to the set value troubleshooting method: 1, if the laboratory temperature controller temperature is set too low, we can set the temperature controller at the desired temperature. 2. If the laboratory safety switch is set too low, we can set the safety switch to the desired temperature. 3, if it is a heating system, electromagnetic relay, controller failure, can contact Dongguan Kewen aftermarket department for debugging and repair.

Fault 3: There is a normal spray and the air compressor is not operating normally. Troubleshooting: In general, for the safety of the equipment, the air compressor of the salt spray tester is generally equipped with an automatic protection system. When abnormal use of salt occurs When the fog tester is in operation, the compressor will automatically stop running, so when this type of malfunction occurs, you can use it as usual.

Fault 4: Salt spray tester equipment spray does not time troubleshooting troubleshooting method: When this type of failure occurs, it should immediately check whether the laboratory temperature rose to the specified temperature, because if the temperature does not reach the preset temperature, the timing device sure that the experiment has not yet begun Therefore, such faults can be discharged by checking the preset temperature and the actual temperature; of course, it is also possible that the set time and the spray time are the same, resulting in the inability to observe the timing.

Fault 5: The touch screen does not respond to failure troubleshooting method: As the salt spray testing machine equipment gradually becomes intelligent, so now the factory's salt spray testing machine mostly uses a touch screen; after excluding the screen locking factors, you can contact the Shanghai Jane customer after-sales department Commissioning and repairs.

Fault 6: The saturation bucket of the salt spray tester cannot rise to the set value. Troubleshooting: 1. If the temperature of the saturated bucket temperature controller is too low, we can set the temperature controller to the desired temperature. 2. If the saturation bucket safety switch is set too low, we can set the safety switch to the desired temperature. 3, if the heating system, electromagnetic relay, controller failure, can contact Dongguan Kewen aftermarket department for debugging and repair.

China Flat Bar Punching Machine Suppliers