Infrared dome camera, infrared night vision dome camera, outdoor infrared dome camera, and infrared dome camera are the front-end image acquisition devices frequently used in video surveillance systems. The infrared dome camera integrates dome control and array infrared lamp power supply. Various functional modules, such as control and integrated zoom movement control, and more and more intelligent functions are completely an intelligent system. Therefore, when you install the infrared dome camera, you must remember the following eight notes so that you can quickly and easily install and operate the infrared dome camera.
Infrared dome installation considerations
The first one: After getting the IR dome camera, remember that the whole process should be handled with care. Only the infrared dome camera that loves you will "return" you. It is a lower failure rate and longer use. life.
Second: Many people like to use their hands to raise the tail of the infrared dome during the installation process. The core of the infrared dome is connected to the conductive slip ring, and the core is directly connected. It is easy to have bad interfaces. The best way to do this is to use your hands to hold the smart dome.
Item 3: During the installation process, the power cable must be connected to the infrared night vision dome. At the same time, the power adapter of the infrared dome must not be extended, and the centralized power supply mode must not be used. If centralized power supply is used, the voltage reaching the outdoor infrared dome may be insufficient. Especially in thunderstorms, the resistance resistance increases. Insufficient power supply may cause the infrared infrared dome board to burn out and thus cannot be controlled.
Item 4: When wiring, remember to distinguish RS485 communication line and power line. If RS485 is connected to the power supply, the smart ball machine may burn on the spot, so you must carefully read the logo and protect the relevant logo to facilitate yourself. Also convenient for future maintenance.
Item 5: When installing, the 220V power cord must be connected to the dome. Do not use the low voltage remote transmission power supply. Do not extend the line of the power adaptor equipped with the dome to avoid voltage shortage or power interference.
Item 6: Infrared dome is totally different from indoor environment and outdoor environment. When installing outdoors, strict waterproofing must be performed. You may say that outdoor infrared dome camera is not waterproof? The ball machine itself is waterproof, but when installed, the infrared ball machine must always be connected with the outside world, there is always a joint, if the joint location, improper method of design, or a bad seal may cause water, especially the use of lifting When mounting or self-made wall brackets are installed, we must deal with the waterproof problem carefully!
Item 7: It is very important to install an infrared dome and choose the right power source. Why? If the power is too low to reach the rated power of the infrared dome, the capacitance of the main control board of the infrared dome will continue to discharge. This will damage the components of the infrared dome and shorten the life of the infrared dome. At the same time, the infrared power will not meet the requirements; if the power is too large, it will cause waste first, and secondly, the power supply will have a large volume and weight, which will inconvenience the installation.
Item 8: It is not enough to do the above items well. It is the most important to read the instructions carefully. While checking whether the above precautions are done, we still need to follow the instruction manual to further set up and operate the dome camera. Remember to blindly set. , Operation, installation, construction, or even damage the infrared dome camera, here you need to remind again that you must carefully read the instructions, according to the instructions of the instructions for related operations!
Reproduced from the Internet, the copyright belongs to the author, if there is any infringement, please inform
Pyrolysis Machines reactor material: Alloy Steel Plate;
Pyrolysis Machines working pressure: No pressure;
Pyrolysis Equipment working temperature: 360-400℃,different according different plastic components.
Plastic Pyrolysis Plant dominates in converting varities waste plastic into fuel oil and carbon black, based on eco-friendly and safe working condition. Fuel oil can be used as heating fuel, carbon black can be recycled to be made of bricks, road,cement,etc...
