Quadcopter Esc,Dji Esc,Drone ESC, ESC for Brushless Motor, Quadcopter Esc,Drone ESC, ESC for Brushless Motor Drone, Motor Speed Controller shenzhen GC Electronics Co.,Ltd. , https://www.jmrdrone.com
1, the scale to be placed, it is best measured with a degree scale.
2. The four corners of the weighing platform should be in contact with the air at the same time. Do not have the phenomenon of dangling. When checking, you can use the hands to move the four corners and move them up and down to see if the bottom corner can reach the air. If it is vacant, the above screws can be adjusted to make the equalizer.
3, in the use of the process to make the scale platform in the center of the pit, so as not to touch the edge of the concrete air, so that the scale is not allowed,
4. When weighing, place the goods as far as possible in the middle of the weighing platform, and insist on stability,
5. Be careful when pushing the cart onto the weighing platform or placing the goods with a forklift. Do not shift the weighing platform so that errors will occur.
6, to adhere to the clean in the pit, do not have to throw in the dross and articles, so that will make the scale platform stuck or weighing results than the actual weight reduction,
7. Each plug on the electronic truck scale instrument should be firmly inserted, and the forbidden screws on the plug must be locked. In the situation that the instrument power switch is turned on, the signal cable and the printer plug are prohibited from being pulled down.
8, electronic truck scale instrument is equipped with a battery, usually do not always plug the power cord in the power cord socket, this will reduce the battery life, as long as the instrument shows the low pressure prompts appear on the screen before stopping charging, charging time is 8- 10 hours (continuous charge)
9, the printer's power cord plug should be plugged in a good contact with the socket, to prevent power outages, prevention, printing, stuck, when the printer changes the printing paper, it is necessary to adhere to clean hands, can not have oil, otherwise it will change the rubber wheel appearance Hard, slippery to form no paper. ??
The installation of an electronic truck scale is a simple task. Can it be used safely after installation? Of course, the answer is not, today Xiaobian for everyone to popularize the installation of a good electronic truck scale when using the precautions, together to understand it!