The working aerial vehicles suddenly stopped inexplicably, and after a while, they could start normal operations again, but then they turned off again. Why is such an intermittent flameout in the end? The intermittent flameout of the engine of the aerial vehicle can be summarized as the following reasons: 1. It is necessary to carefully check whether the spark plugs of the high-altitude truck and the operation of the engine and the fuel pump, the air nozzle of each cylinder, and the fuel pump circuit are all normal. In addition, the interval between the intake air and the exhaust valve must be checked. Whether the pressure value of the cylinder, the presence of air intake manifold leaks, the operation of the fuel vapor control solenoid valve, the operation of the EGR valve cylinder, etc., are all within the range of production. Whether the relevant line connector of the electric control fuel injection system of the aerial vehicle has loosened or the like. 2. In order to check the hydraulic pressure value of the entire vehicle under the aerial working platform, the system pressure value cannot exceed 16 Mpa. 3. The idle speed of the engine of the aerial vehicle is not stable, or the idling speed is too low. It is necessary to adjust the screws of the engine idle speed blackly, or to adjust the idle speed through the throttle cable. 4. When the aerial working platform is under work, if the engine building fails to start normally, it cannot be started. Because the legs of the vehicle are all supported on the ground, there is no way to move and the service station can be immediately looked for. Personnel go to the job site to carry out repairs. If not, they can only use the starter as an emergency pump. If the driver does not step on the clutch, the driver will be forced to take the vehicle back to the vehicle. Use a trailer to pull the aerial vehicle to the repair station for maintenance. Two Dimensional Movement Mixer
EYH two-dimensional movement mixer is mainly composed of three parts such as the drum, oscillating frame and machine frame. The drum is installed on the oscillating frame, supported by four rollers and positioned axially by two catch wheels. In the four supporting rollers, the two driving wheels are pulled by the rotation power system to make the drum turn. The oscillating frame is driven by a group of crank rocker mechanism, which is installed on the machine frame. The oscillating frame is supported on the machine frame by the bearing assembly.
Features:
The drum of the EYH two-dimensional movement mixer can carry out two movements simultaneously: one is the rotation of the drum and the other is the oscillation of the drum along with the oscillating frame. While the materials to be mixed carry out rotation, turning and mixing along with the drum, they also make reciprocating mixing movement along with the oscillation of the drum. Under joint action of the two movements, the materials are sufficiently mixed within a short time. The EYH two-dimensional movement mixer is suitable for mixing all powder and granular materials.
Drawing:
Two Dimensional Movement Mixer,Two Dimensional Movement Blender, Two Dimensional Mixing Machine, 2D Movement Mixing Machine, 2D Movement Blending Machine Jiangyin Jirui Machinery Manufacturing Co,LTD , https://www.jyjiruimachine.com
