Tr-412 Tubeless Snap-in Rubber Tire Valve Stem (MG50900)

Cutting Torches

The equipment and accessories for oxygas cutting are the same as for oxygas welding except that you use a cutting torch or a cutting attachment instead of a Welding Torch. The main difference between the cutting torch and the welding torch is that the cutting torch has an additional tube for high-pressure cutting oxygen. The flow of high-pressure oxygen is controlled from a valve on the handle of the cutting torch. In the standard cutting torch, the valve may be in the form of a trigger assembly like the one in figure 4-11. On most torches, the cutting oxygen mechanism is designed so the cutting oxygen can be turned on gradually. The gradual opening of the cutting oxygen valve is particularly helpful in operations, such as hole piercing and rivet cutting.



Figure 4-11.-One piece oxygas cutting torch.

Torch Body

Most welding torches are designed so the body of the torch can accept either welding tips or a cutting attachment. This type of torch is called a combination torch. The advantage of this type of torch is the ease in changing from the welding mode to the cutting mode. There is no need to disconnect the hoses; you just unscrew the welding tip and then screw on the cutting attachment. The high-pressure cutting oxygen is controlled by a lever on the torch handle, as shown in figure 4-12.



Figure 4-12.-Cutting attachment for combination torch.

Cutting Torches

Cutting Torches,Gas Cutting Torch,Plasma Cutting Torch,Air Cooled Cutting Torch

Changzhou Edaweld Trading Company Limited , https://www.edaweld.com