This report comes from Erik Haak: At 4:31 p.m. on Friday afternoon, the Englewood Fire Alarm Office dispatched a working fire response to 1650 W. 75th Place. By 4:34 p.m., Truck 50 confirmed a fire in a single-story, 50x100 ordinary commercial building. The crew reported a possible truss roof and immediately called for the Still & Box. Battalion 20 established defensive operations, with Engine 129 operating in Sector 1 and Tower Ladder 39 positioned in a lot to the east of the structure. Squad 5 used its snorkel on the parkway east of the building as well. At 4:56 p.m., 2-2-5 pulled a 2-11 alarm. Tower Ladder 34 was set up to the west of the fire building at the end of Paulina Street. The first photo in my series was taken nearly an hour after the fire began. The 2-11 alarm was struck out at 6:21 p.m., and crews remained on scene until just before 8:00 p.m., actively searching for hot spots and ensuring the fire was fully under control. These images capture the intensity and scale of the incident, showing the fire's progression and the efforts of the responding units. Each photo provides a different perspective, highlighting the challenges faced by firefighters during this event. Erik Haak photo Erik Haak photo Erik Haak photo Erik Haak photo Polyester Wood-based Panel Belts There are mainly the following types of polyester mesh belts used in the wood-based panel industry: 1. The Intermediate belt must pass through the bull nose roller (6 mm thin shaft), and it can still maintain balanced conveying, easy to correct deviation, strong and durable, and high temperature resistant. We use a special monofilament woven surface with a special coating treatment and a spiral interface (instead of hot pressing) to meet the equipment's requirements for mesh belts, which is convenient for installation and greatly shortens downtime, ensuring the continuity, stability and efficiency of modern industrial production. 2. The Pre-heater Belt has good heat dissipation, stability, wear resistance and other characteristics, making the slab forming effect more obvious, and adopts spiral ring and pin ring interface 3. The Ventilation Belt adopts special silk thread, which is wear-resistant and tensile-resistant and can adapt to any chemical substances introduced in the artificial board industry, making the mesh belt have excellent breathability. The anti-static black silk thread makes the mesh belt have good anti-static and anti-sticking properties, effectively preventing the fiber from blocking the mesh belt and improving production efficiency. The joints use endless, pin ring, and spiral ring, which can be selected according to the specific use of customers. 4. The Forming Belt has the characteristics of strong structural stability, easy correction and strong wear resistance, which effectively prevents the deviation of the mesh belt and improves the work efficiency. The joints can use steel card joints, spiral ring joints, etc. 5. Dryer Belt allows the material to be dried to the maximum extent before entering the silo. Polyester Mesh Belt, Deaeration Belt, Drying Belt, Intermediate Belt, Matpre-heater Belt Huatao Industrial Belt Co., Ltd. , https://www.huataobelt.com
Huatao has been focusing on wood-based panel belts for more than 20 years. Through continuous research and development and experiments in recent years, it has been proved that our products are targeted and applicable to all MDF, HDF, PB, OSB (particle boards, medium fibers, oriented strand boards), cardboards and softboards. At present, it has been widely used in machine such as Simbelcomb, Dieffenbacher, Shanghai Board Machine, Dunhua Yalian, etc. at home and abroad, and is well received by customers.